Monday, March 30, 2009

"Porto Span"


Here we have a tool for adjusting the pivot pin on a Strider knife. It is made from 316 series stainless steel and features both the spanner for the large Strider knives (NOT FOR THE PT MODEL) as well as an 1/8 hex wrench. The two halves screw together using a 1/4-28 thread with an "O" ring at the bottom of the thread to keep debris out. Dimensions are 3/8 thick x 5/8 wide x 1 &  3/8 long.
                                       ATTENTION PLEASE:
If  you have not adjusted the pivot pin on your Strider knife before, I suggest that you hold the end of the knife with the pivot pin in very hot if not boiling water for a minute to loosen any thread lock (Loctite) that the good folks at Strider may have applied.



at

5 comments:

  1. UnknownApril 19, 2009 at 12:51 AM

    Very Cool item :) Are these still available?

    Any chance of making a smaller spanner tool for the Strider PT model? So far I don't think ANYONE make one....I think it would be very popular....

    Cheers,
    Scott
    www.thelanyardzone.com

    ReplyDelete
  2. Kenn Jordan Jr.April 19, 2009 at 10:29 AM

    Thank You,
    Moore Cutlery has a few with more to come soon.

    As for as one to fit the PT, it shouldn't be a problem so I'll look into it.

    Thanks again,
    Kenn

    ReplyDelete
  3. Kenn Jordan Jr.January 4, 2010 at 5:00 PM

    Josey,
    I should be returning to work by the end of January, so I hope to have a Hinderer model available shortly after that...:)
    Kenn

    ReplyDelete
  4. thepaintballguyJanuary 5, 2015 at 11:49 PM

    Did you ever come out with a Hinderer model Kenn? Curious.

    ReplyDelete
  5. thepaintballguyJanuary 5, 2015 at 11:52 PM

    Never mind...I found it! ;-)
    Spanner Bullet

    ReplyDelete